Sealless Pumps, Magnetic Drive Pump, Mag, Kontro, Ansimag, Canned Pumps

HMD Kontro

30 plus years of magnet drive experience ! All HMD/KONTRO pumps are sealless. Single-stage centrifugal configurations are available for flow rates to 3,000 GPM/681 m³/hr and heads to 700 feet/213 m; Pumping temperatures can reach a max of 825 F !

Availability: MI

............................................................................................

Nikkiso Canned Motor Pump

Nikkiso Canned Motor Pump Models are single stage, sealless, centrifugal pumps available in either horizontal or vertical configurations. The pumped liquid lubricates the single shaft's bearings while efficiently cooling the motor.

The canned motor pump's operating principle is significantly enhanced by the fact that no rotating shaft penetrates a pump housing, The result is a design inherently capable of "dual containment", i.e. primary at the stator liner and redundant protection at the outer stator band/terminal lug plate.

Availability: MI

............................................................................................

ULTRAChem
Magnetic Drive Pump

FTI's ULTRAChem Magnetic Drive Pump is a magnetically driven, ANSI dimensional pump engineered for the utmost reliability. ULTRAChem™ performs efficiently with greater reliability and lower maintenance requirements for increased productivity and minimal operating costs in chemical process applications.

Availability: MI, IL

............................................................................................

Availability: MI, IL, OH, PA

Durco Mag-Drive Pumps

Flowserve metallic magnetic drive pumps are used wherever process leakage cannot be tolerated. Zero leakage requirements include emissions reduction, toxic services, flammable liquids, expensive liquids, ultrapure services, difficult to seal liquids.

Guardian and Chemstar MD process pumps utilize the same impellers and casings as the conventionally sealed Mark III and Chemstar process pumps. The silicon Carbide Bearings offer unmatched corrosion and abrasion resistance.

............................................................................................

ANSIMAG Non-metallic
Centrifugal Pumps

All wetted parts are non-metallic to handle a wide range of corrosives and solvents up to 250°F (121°C) without corrosion. An innovative rear casing generates no eddy currents thus eliminating heat generation and energy costs.

And because ANSIMAG pumps are magnetically driven and sealless, there are no leaks, no emissions, no costly seal maintenance - no problems.

Availability: Ohio, Michigan

............................................................................................

ANSIMAG Non-metallic Centrifugal Pumps

ANSIMAG Non-metallic
Centrifugal Pumps